Dell E2009W 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Dell E2009W에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell E2009W 49 페이지. Lcd monitor
Dell E2009W에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사용자 설명서 (30 페이지)
페이지 인쇄
- Button "Menu" on front bezel connects to U105 (TSUM58EHJ-LF-2) #50 through CN104 #1, U105
#50 Voltage is defined as "Menu".
- Button "SELECT" on front bezel connects to U105 (TSUM58EHJ-LF-2) #122 through CN104 #4,
U105 #122 Voltage is defined as "SELECT".
- LED Indicator on Front Bezel
a. When press button "power", U105 (TSUM58EHJ-LF-2) #123 be send in low Voltage, make
Q107#3 sends out high Voltage , and then to CN01#5 on keypad, LED green on.
b. When in "Suspend" mode, U105 (TSUM58EHJ-LF-2) #124 sends out a low Voltage, make
Q108#3 sends out high Voltage and then to CN01 #7 on keypad, LED Amber ON.
2.3.4 MATAR CHIP U105 (TSUM58EHJ-LF-2)
- U105 (TSUM58EHJ-LF-2) #91~#100 output 8 bit even and #77~#86 output 8 bit odd LVDS digital
data to panel control circuit through CN103.
- U105 (TSUM58EHJ-LF-2) #73 output PPWR "H" potential to make Q104 conducted, and then
make Q101 conducted, +5V flow to CN103#1~#3 as Panel Vdd .
- U105 (TSUM58EHJ-LF-2) #109 output CCFL_ON/OFF "L" potential to control Inverter on/off.
- U105 (TSUM58EHJ-LF-2) #125 outputs Brightness "PWM" signals to control CCFL brightness.
- TCLK by Crystal 14.318MHz input to U105 (TSUM58EHJ-LF-2) #128/#127.
- U105 (TSUM58EHJ-LF-2)#108 is RESET signals input pin
Please refer to U105 (TSUM58EHJ-LF-2) Pin Assignments table in page
2.3.5 Regulator Circuit
- +3.3V is generated from Regulator U101 which is supplied by+5V via R101 and through C104
filtering,
-+1.8V is generated from Regulator U102 which is supplied by+3.3V through C106 filtering,
3. FACTORY PRESET TIMING TABLE
Standard
VESA
IBM DOS
4. Power On/Off Sequency
Hardware power On/Off
When power cord plug into AC socket, Power provides 26V and DC_5V.
DC_5V is main voltage for panel and Regulator U101.
DC_3.3V is coming from Regulator U101, DC_3.3v is main voltage for U105. When DC_3.3V input to
U105 and U105 reset circuit active, U105 all registers will be set to default, that means finish hardware
power on.
When pull out power cord from AC socket,the system shut down instantly for no supply
Software power On/Off
- When press power key, U105 #4 receives low pulse, then U105 (TSUM58EHJ-LF-2) will be wake up
Resolution
640 x 480
640 x 480
800 x 600
800 x 600
1024 x 768
1024 x 768
1152x864
1280x1024
1280x1024
1680x1050
720 x 400
Horizontal Frequency
(KHz)
31.469
37.500
37.879
46.875
48.363
60.023
67.500
48.483
60.087
55.935
31.469
11
Service Manual
Vertical Frequency
(Hz)
59.940
75.000
60.317
75.000
60.004
75.029
75.000
60.042
75.034
59.887
70.087