Dell E2010H - 20" LCD Monitor 사용자 설명서 - 페이지 28

{카테고리_이름} Dell E2010H - 20" LCD Monitor에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell E2010H - 20" LCD Monitor 31 페이지. Flat panel monitor
Dell E2010H - 20" LCD Monitor에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사용자 설명서 (30 페이지)

페이지 인쇄

Back to Contents Page

Troubleshooting

Dell™ E2010H/E2210H/E2310H Flat Panel Monitor

Self-Test

Common Problems

Product Specific Problems

CAUTION:

Before you begin any of the procedures in this section, follow the

Self-Test

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly

connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer. To ensure a proper Self-Test operation, remove both Digital (white connector) and the Analog

(blue connector) cables from the back of computer.

3. Turn on the monitor.

The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.

While in self-test mode, the power LED remains blue. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll

through the screen.

4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged.

5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning

properly.

NOTE:

Self-test feature check is not available for S-Video, Composite, and Component video modes.

Built-in Diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or

with your computer and video card.

NOTE:

You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode.

To run the built-in diagnostics:

Downloaded from ManualMonitor.com Manuals

Safety

Instructions.