Dell PowerVault NX1950 설치 및 문제 해결 매뉴얼 - 페이지 26

{카테고리_이름} Dell PowerVault NX1950에 대한 설치 및 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault NX1950 48 페이지. For vmware esx server software
Dell PowerVault NX1950에 대해서도 마찬가지입니다: 배포 매뉴얼 (34 페이지), 중요 정보 매뉴얼 (26 페이지), 시작하기 (49 페이지), 배포 매뉴얼 (38 페이지), 업그레이드 매뉴얼 (18 페이지), 참조 매뉴얼 (4 페이지), 설정 (2 페이지), 사용 (2 페이지), 구성 매뉴얼 (11 페이지)

페이지 인쇄

Creating a Highly Available iSCSI Target Using Microsoft iSCSI Target 3.0

1 Click Start→ Administrative Tools→ Services→ Microsoft iSCSI Software

Target→ (right-click) Stop, to stop the iSCSI service.

2 Stop the Microsoft

3 On the Active node, go to Start

Administrator

4 Enter the following required information and click Next:

–

Name

–

Description

–

Resource Type: Select Generic Service

–

Group: Select Cluster Group

5 Verify that all cluster nodes are in the Possible Owners window and click

Next.

6 Select the following dependencies, click Add, and then click Next:

–

Cluster IP Address

–

Cluster Name

–

Physical Disk of Choice

NOTE:

7 In the Service Name field, type WinTarget, and then click Next.

8 When prompted for the registry key, click Add, type

Software\Microsoft\iSCSI Target, and then click Finish.

9 Right-click on Resource and select Online.

10 On the active node, go to PowerVault NX1950 Management Console

Microsoft iSCSI Software Target

11 Select the physical disk that you chose in step 6. Right-click on the disk

and complete the wizard steps to create a LUN.

12 Right-click Microsoft iSCSI Software Target and then click Create New

Target.

13 Right-click the new Target and add the existing LUN that you created in

step 11.

NOTE:

If you are migrating from Microsoft Target 3.0 to Microsoft Target 3.1, see

the Dell PowerVault NX1950 Systems Solution Upgrade Guide.

Managing Your Cluster

iSCSI service on each cluster node and set it to Manual.

→

Groups

Cluster Group (right-click)

Do not select quorum disk.

→

Administrative Tools

→

Devices.

→

Cluster

→

New Resource.

→