Dell SD630-S 배포 매뉴얼 - 페이지 17

{카테고리_이름} Dell SD630-S에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell SD630-S 31 페이지. Designed for scality ring

Storage network

The Dell Storage Designed for Scality RING solution requires a switch for the storage network. The

selection depends on the NDCs selected for the Dell SD7000-S and Dell SD630-S servers.

Dell recommends having two bonded network connections from each server to the application network

routed through two separate, redundant switches.

About this task

To install the Dell Storage for Scality RING solution, complete the following steps:

Steps

Unpack the Dell SD630-S and Dell SD7000-S servers.

Install the Dell SD630-S and Dell SD7000-S servers into the rack. For more information about

installing the server into the rack, see the Rack Installation document included with your solution.

Install the HDDs and SSDs in the Dell SD7000-S servers.

Connect the network interface connections to the appropriate network switches.

Connect each server to an electrical outlet.

Turn on the system by pressing the power button.

Before you begin, read through the following documentation:

•

Rack installation instructions shipped with your Dell servers.

•

Dell Storage Designed for Scality RING Getting started Guide

•

Dell Storage Designed for Scality RING Owner's Manual

NOTE: For weight stability, always load the rack by using a bottom-up approach. Locate the Dell

DS7000-S server near the bottom of the rack.

Before installing the servers, ensure that the space allocated for the Dell SD7000-S server does not

contain a power strip installed internal to the rack because the server completely fills the space from the

front to back doors.

The hard drives are packed in separate boxes from the server. To remove the top cover from the Dell

SD7000-S server and install the drives, follow the instructions in the Owner's Manual.

Installing the hard drives into the Dell SD7000-S Single Node server

Install HDDs and SSDs into the open slots in each Dell SD7000-S server as shown in the figures here. The

Physical Server located in the lower sled A connects to all 90 slots. Install the SSDs in the highest

numbered slots and install the HDDs in the lowest numbered slots. Insert the drive blanks in all remaining

slots.