Dell EMC PowerSwitch S6100-ON 설치 매뉴얼 - 페이지 32

{카테고리_이름} Dell EMC PowerSwitch S6100-ON에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC PowerSwitch S6100-ON 48 페이지.

3. Use a flat-blade screwdriver to tighten the screws that secures the bare wires into the wiring block.

4. Secure the site's DC power source wires to the other side of the wiring block, see steps 1 and 3.

NOTE:

Do not cross the wires—in the wiring block, red aligns with red and black aligns with black.

5. Insert the DC power connector into the power socket of the DC PSU. Ensure that the connector pins firmly seat and you

hear the click of the power connector's left and right levered clamps lock into place.

NOTE:

Never try to force the power connector into or out of the DC PSU power socket.

NOTE:

To remove the power connector from a DC PSU, squeeze the levers on both sides of the connector. Doing so

disengages the power connector's clamps. While continuing to squeeze, pull the power connector from the DC PSU socket.

AC or DC power supply replacement

CAUTION:

Disconnect the power cord before removing the power supplies. Also, disconnect all power cords

before servicing.

NOTE:

The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the

S6100–ON chassis.

NOTE:

If a PSU fails, you must replace the entire unit. There are no field serviceable components in the PSU. To request a

hardware replacement, see

1. Disconnect the power cable from the PSU.

2. Use the grab handle and the orange tab to slide the PSU out of the power supply bay.

3. Use the grab handle and the orange tab on the replacement PSU to slide it into the power supply bay.

4. Attach the power cord to the replacement PSU.

NOTE:

The system powers up when the cables are connected between the power supply and the power source.

Power supplies

Dell

Support.