Dell Force 10 매뉴얼 - 페이지 20

{카테고리_이름} Dell Force 10에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force 10 29 페이지. Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

Figure 16.

3. Click OK and then Quit to return to the command prompt. The FCoE client should now start as

part of SLES 11 SP2s boot process, and the FCoE LUNs should be available after the system

boots.

Troubleshooting

Various conditions may exist on the network that interferes with FIPS snooping, particularly on

congested networks.

If the FCoE client is unable to see the FCoE VLAN after booting, restart the lldpad and fcoe

daemons as a troubleshooting step.

1. To restart the lldpad and fcoe daemons, run the following commands:

rcfcoe stop; rclldpad stop; rclldpad start; rcfcoe start

2. Then check the FCoE VLAN status by running fcoeadm -i . Figure 17 shows VLAN status

details.

Configure FCoE to start at system boot.