Dell Force10 C150 빠른 시작 매뉴얼 - 페이지 28

{카테고리_이름} Dell Force10 C150에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 C150 33 페이지. Quick start guide

Task

Configure an IPv4 or IPv6

management route to the

network from which you

are accessing the system.

Configure a Username and Password

Configure a system username and password to access the system remotely.

Task

Configure a username

and password to

access the system

remotely.

The EXEC Privilege mode is accessed by the enable command. Configure a

password as a basic security measure. When using a console connection, EXEC

Privilege mode is unrestricted by default; it cannot be reached by a VTY

connection if no password is configured. There are two types of enable

passwords:

•

enable password stores the password in the running/startup configuration

using a DES encryption method.

•

enable secret is stored in the running/startup configuration by using a

stronger, MD5 encryption method.

Dell Force10 recommends using the enable secret password.

Task

Create a password to

access EXEC

Privilege mode.

Installing the Software

Command Syntax

management route {ipv4-address

| ipv6-address}/mask gateway

Command Syntax

username username password

[encryption-type] password

Command Syntax

enable [password | secret] [level level]

[encryption-type] password

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION