Dell PowerEdge M420 릴리스 정보 - 페이지 26

{카테고리_이름} Dell PowerEdge M420에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M420 27 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M420에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 매뉴얼 (25 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 매뉴얼 (38 페이지), 기술 매뉴얼 (46 페이지), 기술 매뉴얼 (48 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

페이지 인쇄
Dell PowerEdge M420 릴리스 정보
Layer 3
IPv6 MTU
Description
IPv6 Fragmentation Support
IP Routing
Description
Static IP routes do not show with the
show ip route command
VRRP VRID limit is 20.
24
User Impact
The switch is not fragmenting the datagram and forwards even when the IP MTU
of the forwarding interface is set to a lower value (than the datagram size).
IPv6 frames are not allowed to be fragmented. IPv6 frames forwarded in silicon
can be up to the lesser of 9216 octets or the link MTU. These frames are
forwarded by the switching silicon with no effect. If a frame exceeds the link
MTU for a port, it is discarded silently.
If a packet is sent to the CPU or originated on the CPU and it exceeds the IPv6
MTU, then the packet still will not be fragmented. Instead, an ICMP error
message is returned to the sender. The maximum IPv6 MTU is 1500 bytes.
Administrators are advised to only adjust the link MTU and let the system
automatically adjust the IPv6 MTU based on the link MTU.
User Impact
The switch UI will attempt to discourage the configuration of static ip route
entries for which a matching subnet does not exist. Certain configuration
sequences may still allow such routes to be configured. Configuring an IP address
on a VLAN which matches the next hop IP address of the static route in all
significant bits will allow the display of the route using the show command.
The switch will only support VRRP environments with 20 or less VRRP routers.
System Firmware Version 4.1.0.6