Dell PowerEdge XL 5133-4 시작하기 매뉴얼 - 페이지 23
{카테고리_이름} Dell PowerEdge XL 5133-4에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge XL 5133-4 38 페이지. Dell poweredge m i/o aggregator getting started guide
페이지 인쇄2 At the EXEC mode prompt, enter enable. At the EXEC Privilege prompt,
enter configure to reach the configuration command mode.
FTOS> enable
FTOS# configure
FTOS(conf)#
3 (CLI only) At the configuration mode prompt, enter the hostname name
command to configure a hostname for the Aggregator, where name is a text
string of up to 20 alphanumeric characters.
Host names must start with a letter and end with a letter or number.
Characters within the string can be letters, numbers, and hyphens.
FTOS(conf)# hostname Aggregator1
FTOS(conf)#
4 (CMC-supported) To reconfigure the default username and password,
enter the username name password password command, where name is a
string of up to 63 alphanumeric characters and password is a string of up to
32 characters. Both values are case sensitive; spaces are supported.
FTOS(conf)# username admin password dellAgg1
FTOS(conf)#
5 (CLI only) At power up, the default VLAN for all ports is VLAN 1. To
reconfigure the default VLAN, enter the default vlan vlan-id command;
for example:
FTOS(conf)# default vlan 3
6 (CMC-supported) To reconfigure the SNMP community name used for
read-only management access to the switch, enter the snmp-server
community name ro command, where name is a text string of up to 20
alphanumeric characters and ro specifies read-only permission.
FTOS(conf)# snmp-server community dellSNMP ro
7 (CMC-supported) By default, the IP address and subnet mask of the out-
of-band management interface used for remote SNMP or Telnet access is
assigned by a DHCP server. You can reconfigure the default setting by
specifying an IP address with the following commands:
interface ManagementEthernet slot/port, where is slot is 0-1 and port is 0.
ip address ip-address/mask, where ip-address is in dotted-decimal format
(A.B.C.D) and mask is a subnet mask in /prefix-length format (/xx).
no shutdown enables the interface.
Installing and Configuring the Aggregator
23