Dell PowerEdge XL 5133-4 시작하기 매뉴얼 - 페이지 25
{카테고리_이름} Dell PowerEdge XL 5133-4에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge XL 5133-4 38 페이지. Dell poweredge m i/o aggregator getting started guide
페이지 인쇄13 (CLI only) To verify the reconfigured settings, enter the show running-
config command.
FTOS(conf)# show running-config
14 (CMC-supported) To save reconfigured settings to the startup
configuration, enter the write memory command.
FTOS(conf)# write memory
For more information about Aggregator configuration using the CLI, refer to
the Dell Force10 FTOS Configuration Guide for the PowerEdge M I/O
Aggregator.
Aggregator Auto-Configuration
After the Aggregator powers on, it auto-configures and is operational with
software features enabled, including:
•
VLANs: All ports are configured as members of all (4094) VLANs. All
VLANs are up and can send or receive layer 2 traffic. For more information,
refer to "Configuring VLANs" on page 27.
•
Data Center Bridging Capability Exchange Protocol (DCBX)
•
Fiber Channel over Ethernet (FCoE) connectivity
•
FCoE Initiation Protocol (FIP) snooping
•
Hybrid ports: Ports are administratively up and auto-configured to operate
as hybrid ports to transmit tagged and untagged VLAN traffic.
•
iSCSI optimization
•
IGMP snooping
•
Jumbo frames: Ports are set to a maximum MTU of 12,000 bytes by
default.
•
Link aggregation: All uplink ports are configured in a single LAG
(LAG 128).
•
Link Layer Discovery Protocol (LLDP): Enabled on all ports.
•
Link tracking: Enables server-facing links to be brought up only if the
uplink port-channel (LAG 128) is up.
Installing and Configuring the Aggregator
25