Dell 540 - USB Photo Printer 540 서비스 매뉴얼 - 페이지 22
{카테고리_이름} Dell 540 - USB Photo Printer 540에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 540 - USB Photo Printer 540 37 페이지. Dell™ photo printer 540 user's guide
Dell 540 - USB Photo Printer 540에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (43 페이지)
페이지 인쇄
Back to Contents Page
Replacing Memory Module(s)
Dell Studio™ 540 Service Manual
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Locate the memory modules on the system board (see
4. Press out the securing clip at each end of the memory module connector.
1
securing clip
2
memory module connector
5. Grasp the module and pull it upwards.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
NOTICE:
Do not install ECC memory modules.
NOTICE:
If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that
you may have, even if you purchased the new modules from Dell™. If possible, do not pair an original memory module with a new memory module.
Otherwise, your computer may not start properly. The recommended memory configurations are:
A pair of matched memory modules installed in DIMM connectors 1 and 2.
or
A pair of matched memory modules installed in DIMM connectors 1 and 2 and another matched pair installed in DIMM connectors 3 and 4.
NOTE:
If you install mixed pairs of PC2-5300 (DDR2 667-MHz) and PC2-6400 (DDR2 800-MHz) memory, the modules function at the speed of the slowest
module installed.
6. Ensure that you install a single memory module in DIMM connector 1, the connector closest to the processor, before you install modules in any other
connector.
1 Pair A: matched pair of memory
modules in connectors DIMM_1
and DIMM_2
7. Align the notch on the bottom of the module with the with the tab on the memory module connector.
Begin.
Replacing the Computer
Cover).
System Board
2 Pair B: matched pair of memory
modules in connectors DIMM_3
and DIMM_4
Components).