360 Yield 360 Y-DROP CASE 80 BOOM 사용 설명서 - 페이지 7

{카테고리_이름} 360 Yield 360 Y-DROP CASE 80 BOOM에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 Yield 360 Y-DROP CASE 80 BOOM 11 페이지.

INSTALL BREAKAWAY ASSEMBLY -

ONE PIECE

Figure 13

Step 1

Install breakaway assembly - one piece (1)

using the square U-bolts (2) and the extra

thick washer and Nylock nut. Repeat for

the remaining breakaway assemblies -

one piece.

Hardware Kit C

Figure 14

Figure 14 may show more or fewer mounts than

your installation. The alignment and quantity of the

mounts will depend on your row spacing.

Figure 15

Step 2

Install riser tube assembly (1) into the

breakaway assembly - one piece (2).

Step 3

Install pin (3).

Repeat Steps 2 and 3 for the remaining riser tube

assemblies.

NOTE: Included in most sprayer mount packages

are standard riser mounts to be used when primary

booms are folded and in transport mode. These

standard riser mounts should be mounted in

locations that allow you to relocate the drops away

from potential tire interference. See "Install Riser

Mounts Without Breakaway Assemblies" section on

next page for more instructions.

INSTRUCTIONS 360 Y-DROP

Figure 13

Figure 14

Figure 15

ROGATOR

360YIELDCENTER.COM