ALLNIC AUDIO A-5000 DHT 소유자 매뉴얼 - 페이지 5

{카테고리_이름} ALLNIC AUDIO A-5000 DHT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLNIC AUDIO A-5000 DHT 13 페이지. 300b single-ended pure direct heated triode monoblock power amplifier
ALLNIC AUDIO A-5000 DHT에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지)

페이지 인쇄

Fig.1 Square Wave 50Hz*

• As are all Allnic Audio products, the A-5000 DHT is fully RoHS (EU Reduction of Hazardous

Substances regulation) compliant in construction and materials.

WHAT'S IN THE BOX?

Please check that each shipping box contains the following:

• One (1) Allnic A-5000 DHT monoblock power amplifier.

• One (1) 15 amp IEC type power cord

One (1) Owner's Manual is also provided.

Note:

The A-5000 DHT ships with the tubes installed.

The A-5000 DHT will work with most 15 amp, IEC type aftermarket power cords. The Allnic ZL-

3000 and ZL-5000 power cables will make an excellent match. Of course, only you can

determine the power cord that works most synergistically with the A-5000 DHTs in your

system.

Be sure the A-5000 DHTs are labeled for the AC voltage of your location. If they are not, DO

NOT connect them to your AC outlet. Please contact your Allnic dealer.

We advise that you keep the boxes and other packing materials that your A-5000 DHTs came in. It

will be useful if you sell your A-5000 DHTs or in the unlikely event you need to ship for service.

SAFETY

•

Remove ALL protective cushioning material (e.g., cardboard around the tubes) inside the tube

chimneys before operation. The tube chimneys should contain NOTHING except the tubes. Any

silicone rings or other damping material (not cardboard or Styrofoam packing materials) on the

RS242 should be left ON the tube.

• Disconnect the power cord by pulling the plug, not the cable.

• Do not attempt any repairs. Do not remove the unit's chassis cover without specific

authorization from your Allnic dealer.

• Keep the power cord away from heat sources

• Keep the unit away from liquids – do not allow any liquid to enter the interior of the unit.

Measured by LEADER LAG-126 Audio Signal Generator and KENWOOD CS-4125 Oscilloscope.

Fig.2 Square Wave 1KHz*

Fig.3 Square Wave 20KHz*