ALLO USBRIDGE Aluminum 매뉴얼 - 페이지 4

{카테고리_이름} ALLO USBRIDGE Aluminum에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLO USBRIDGE Aluminum 4 페이지.

*** Power Feed Instructions ***

There are 3 choices to feed power to your USBridge:

1. Recommended: Feed power to the DC connector on bottom (not to the microUSB)

since it accepts 3A.

2. Advanced: if you decide to open your case, you can remove the J28 jumper of the

USBBoard. You can then power the Sparky AND the USB board independently.

3. Not recommended: microUSB of the Sparky. Only 1.8 Amps can be fed through that connector

and both boards need more at boot up... you will run into problems.

For more information, please visit ALLO.com / Transport / USBridge

Support & Downloads at the bottom of the page