ABB AC500 Series 설치 및 구성 매뉴얼 - 페이지 3
{카테고리_이름} ABB AC500 Series에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB AC500 Series 20 페이지. Scalable plc for individual automation, connection of a dcf77 radio clock to an ac500 via ascii protocol
ABB AC500 Series에 대해서도 마찬가지입니다: 적용 사례 (8 페이지), 매뉴얼 (18 페이지)
—
1 Getting started with AC500 V3 products
1.1 Introduction
This document gives an overview of the steps for the first use of a PLC with AC500 V3 CPU
and describes:
●
installation of the engineering software
Builder" on page 3
●
hardware needed for example projects
●
setting up a first, simple project for a stand-alone CPU with central I/O expansion, including
visualization and web visualization
sion" on page 12
●
commissioning a project for remote I/O expansion with PROFINET
project for remote I/O expansion with PROFINET" on page 56
Fig. 1: Safety
instructions
1.2 Engineering software Automation Builder
For configuring and programming of any AC500 CPU you need the engineering software suite
Automation Builder. Automation Builder is available for download
on page 3.
1.2.1 Installing Automation Builder
Preconditions
You must have admininstrator rights on your PC to install Automation Builder.
In case of an update installation:
Installation
1.
2.
3.
4.
2021/05/14
NOTICE!
Read safety instructions first
Read the safety instructions before first use of the products.
https://to.abb/eER6E15m
Create a project archive before updating Automation Builder. Project archives
contain all project data, including data that is not stored with a *.project file, e.g.
device description files for third party devices.
Go to abb.com/automationbuilder to access the homepage of Automation Builder.
In the "Downloads" section, select "Download Automation Builder".
In the "Latest Automation Builder" section, select "Automation Builder x.x. Download" (x.x
= latest version). This downloads the installer on your PC.
Open the downloaded installer and follow the instructions of the installation manager.
3ADR010584, 2, en_US
Introduction > Installing Automation Builder
Ä Chapter 1.2 "Engineering software Automation
Ä Chapter 1.3 "Hardware AC500 V3" on page 9
Ä Chapter 1.4 "Example project for central I/O expan-
Getting started with AC500 V3 products
Ä Chapter 1.5 "Example
Ä Further information
3