ABB ACH580-01 Series 사용 설명서 - 페이지 4

{카테고리_이름} ABB ACH580-01 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACH580-01 Series 7 페이지. Base drive replacement
ABB ACH580-01 Series에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지), 빠른 설치 및 시작 매뉴얼 (17 페이지), 사용 설명서 (8 페이지), 빠른 설치 및 시작 매뉴얼 (17 페이지), 빠른 설치 및 시작 매뉴얼 (17 페이지)

페이지 인쇄
ABB ACH580-01 Series 사용 설명서
REPLACEMENT INSTRUCTIONS | ACH580-01 VXR UL TYPE 1 , R2/R3/R4
Step
Instruction
9
Using a T30 bit, loosen the two (2) bottom M6 screws securing the
drive, four (4) turns of the screw.
NOTE: Do not remove the screw completely. Only loosen enough to
be able to lift the drive off the screws.
10
Using a T30 bit, loosen and remove the top two (2) M6 screws
securing the drive.
Carefully lift the drive out of channel.
11
Unpack the replacement drive.
R2 Frame: Remove drive cover by pushing up on the sides as
indicated by arrow.
R3 & R4 Frame: Using a T20 bit, loosen and remove one (1) M4x16
screws securing the inverter cover.
12
NOTE: If the drive conduit plate is not reusable, DO NOT remove the
conduit plate on the replacement drive.
Remove knockouts from the conduit assembly.
Install Romex into conduit plate to protect the wires.
13
R2 Frame: Using a T20 bit, loosen and remove two (2) M4x8 screws.
Remove conduit assembly.
R3 Frame: Using a T20 bit, loosen and remove two (2) M4x16
screws. Remove conduit assembly.
R4 Frame: Using a T25 bit, loosen and remove four (4) M5x25
screws. Remove conduit assembly.
Recycle the conduit assembly and hardware.
Diagram
4