Alloy ESM-24T02M 빠른 설치 매뉴얼 - 페이지 2

{카테고리_이름} Alloy ESM-24T02M에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alloy ESM-24T02M 5 페이지. Etherguard managed switch

Unpacking

Open the shipping carton of the Switch and carefully unpack its contents, the carton should

contain the following items:

One - 24 port Fast Ethernet Layer 2 Switch.

Mounting Kit: 2 mounting brackets and screws

Four rubber feet with adhesive backing.

One AC power cord.

One RS-232 cable

CD with Documentation

Installation

Follow the guidelines below to install the Switch.

Do not place any object weighted more than 3Kg on the Switch.

Connect the power cord to the Switch and the power outlet.

Leave at least 10 cm (4 inches) of space around the Switch for heat dissipation.

Desktop or Shelf Installation:

When installing the Switch on the desktop or shelf, please attach the rubber feet to the Switch.

Peel off the protective paper on the pads and attach them on the bottom of the Switch (one at

each corner).

Rack Installation:

The ESM-24T02M Switch is rack-mountable for installation in any EIA 19inch equipment

rack. To do this, first install the mounting brackets on the Switch's side panels (one on each

side), secure them with the included screws, and then use the screws provided with the

equipment rack to mount the Switch in the rack.

Power On the Switch:

The ESM-24T02M Switch has a universal power supply (90 ~ 260V AC, 50 ~ 60Hz power

source). The AC power cord connector is located at the rear of the unit and the On/Off switch

is next to the connector. Connect the power cord from the power outlet to the Switch and push

the On/Off Switch to "ON" position to power on the Switch. After the Switch is powered on,

it will perform "self-diagnostic" (POSD). This process takes about 100 seconds to complete,

during this process, the "DIAG" LED will blink green and the Switch will not respond to any

configuration program and all the connections to the Switch will be unavailable. When the

process is completed, the "DIAG" LED will stay solid green.

Below is a table that describes the meaning of each LED indicator.

2 of 5