ABB ACS880-01 Series 빠른 설치 및 시작 매뉴얼 - 페이지 3

{카테고리_이름} ABB ACS880-01 Series에 대한 빠른 설치 및 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS880-01 Series 17 페이지. Industrial drives
ABB ACS880-01 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 빠른 설치 매뉴얼 (14 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (18 페이지)

페이지 인쇄

6. Remove the covers.

R1...R3

IP55 (UL Type 12)

7. Make sure that the drive is compatible with the grounding system

You can connect all drives to a symmetrically grounded TN-S system (center-grounded wye). With option +E200 or +E202: If

you install the drive to a different system, you must remove the EMC screw (disconnect the EMC filter) and/or remove the

VAR screw (disconnect the varistor circuit).

Frame

Symmetrically grounded

TN-S systems (center-

grounded wye)

R1...R4

Do not remove EMC AC or

VAR screws.

R6...R9

1) A residual current device must be installed in the supply system. In NEC installations the residual current device is only

required at or above 1000 amps.

2) ABB does not guarantee the EMC category or the operation of the ground leakage detector built inside the drive.

WARNING! Do not install the drive on a 525...690 V corner-grounded or midpoint-grounded delta system.

Disconnecting the EMC filter and ground-to-phase varistor does not prevent damage to the drive.

8. Measure the insulation resistance of the power cables and the motor

Measure the insulation resistance of the input cable before you connect it to the drive. Obey local regulations.

Measure the insulation resistance of the motor cable and motor when the

cable is disconnected from the drive. Measure the insulation resistance

between each phase conductor and the PE conductor. Use a measuring

voltage of 1000 V DC. The insulation resistance of an ABB motor must be

more than 100 Mohm (reference value at 25 °C). For the insulation

resistance of other motors, see the manufacturer's instructions. Moisture

inside the motor decreases the insulation resistance. If you think that there

is moisture, dry the motor and do the measurement again.

R4,R5

Corner-grounded delta

and midpoint-grounded

delta systems

Do not remove EMC AC or

VAR screws.

Do not remove EMC AC or

VAR screws. Remove EMC

DC screw.

Do not remove EMC AC or

VAR screws. Remove EMC

DC screw.

R6...R9

IP55 (UL Type 12)

IP21 (UL Type 1)

IT systems (ungrounded

or high-resistance

grounded)

Remove EMC AC, EMC DC

and VAR screws.

Remove EMC AC, EMC DC

and VAR screws.

Remove EMC AC, EMC DC

and VAR screws.

ohm

IP55 (UL Type 12)

IP21 (UL Type 1)

1) 2)

TT systems

Remove EMC AC, EMC DC

and VAR screws.

Remove EMC AC, EMC DC

screws and VAR screws.

Remove EMC AC, EMC DC

and VAR screws.

U1-PE, V1-PE, W1-PE

1000 V DC,

> 100 Mohm