Alloy LED PrimaLine Neon 100 SB 설치 지침 - 페이지 3

{카테고리_이름} Alloy LED PrimaLine Neon 100 SB에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Alloy LED PrimaLine Neon 100 SB 5 페이지. 24v led tape light

Also be sure that the end with the lip is on the correct side.

Refer to the image to the right.

c) Place the Silicone Insert into the gap between the lens and

the diodes. This will ensure a snug connection.

d) Slide the prongs between the PrimaLine Neon Tape Light

and plastic backing. Be sure the prongs are in contact with

the metal connection pads on the back of the PCB of the

tape light (the side without diodes).

To maintain the correct polarity, be sure that the plastic

protrusion on the connector is on the same side as the tape

light diffuser.

Note: If polarity is incorrect, the PrimaLine Neon Tape Light

will not illuminate when connected to power. To correct this,

reverse polarity at the power supply.

e) Secure the metal clamp over the tape light and squeeze

prongs to ensure a tight connection (adjacent to the rubber

washer). Orient the metal clamp so that the notch on the

outside is furthest away from the prongs.

www.AlloyLED.com

page 3 of 5

Installation Instructions

Call: 800.910.LEDS [5337]

Specifications subject to change without notice.

End with Lip

Insert Prongs

Here

Plastic

Backing

Plastic Protrusion

Text: 510.400.6690

Connects to Power

Place Silicone Insert

Here

Diffuser

Notch