Alloy LED AL-60-03-0008 사양 - 페이지 4

{카테고리_이름} Alloy LED AL-60-03-0008에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Alloy LED AL-60-03-0008 7 페이지. Led wifi controller hub

페이지 인쇄

Specifications

LED WiFi Controller Hub "EasyLighting" Application Instructions

Install the App

Download the LED WiFi Controller Hub application from the Apple app store (the app is called "easylighting

easylife" by author Gong Fei) or Google Play by searching for "easylighting".

Set Up the WiFi Hub

Hard-Wired Connection to Router (Recommended):

Connect the WiFi Hub to your router using the included CAT-5 (ethernet)

cable. This will allow you to operate the controller on the same network

you use for the Internet.

1. Open the easylighting application on your smart phone. There will be

a message saying "wireless device not found" - click OK.

2. Go to "Settings" (P1)

3. Select "Connect WiFi LED controller to your home network" (P1)

4. A dialog box saying "Your mobile phone is already connected to the

WiFi controller?" Select "yes", the app will automatically search for the

router. (P2) (P3)

5. Choose your router to connect.

6. Enter the WiFi network password and then press OK. (P3) (P4)

Restore the WiFi Settings to the Factory Default Setting

When we connect to the WiFi Hub through an existing WiFi network, Easylighting will not appear in the list of available networks

unless we reset the router. Then we can use this button to restore the WiFi controller to factory settings. (This function is only

used when connecting to an existing WiFi network).

1. Connect to the existing WiFi network and make sure the WiFi Hub is already configured to this network.

2. Go to "Settings" (P1)

'Easylighting' application manual:

3. Select "Restore WiFi settings to factory default settings." (P6)

Configure

4. Press yes. A dialog box will indicate that it has successfully restored factory settings. Press "OK" (P7)

5. After around 1 minute, Easylighting will appear in the network list again. (P8)

Connect WiFi LED controller to your home network

1)Search and connect the Easylighting

2)Enter easylighting application

3)Short press setting button

4)Short press

(P1)

5)Press yes

, it will search all the router around automatically(P2,P3)

6)Choose router we want connect

7)Enter password and then press OK

www.AlloyLED.com

page 4 of 7

Use direct EasyLighting connection with the WiFi LED

controller

(P1)

(P3.P4)

Call: 800.910.LEDS [5337]

Specifications subject to change without notice.

To Connect Wirelessly to the WiFi LED Controller:

This will operate the controller on its own network

and requires your mobile device to be disconnected

from other wireless networks.

1. Open the easylighting application on your

2. Go to "Settings" (P1)

3. Press "Use direct EasyLighting connection to

4. Press yes. (P2)

Restore WiFi settings to factory default setting

1)Connect exist WIFI and make sure WIFI controller already be

configure to this network

2)Enter the setting interface

3)Short press

Text: 510.400.6690

3)Press yes; it will indicate successful restore factory setting.(P6)

4)Press ok, after around 1 minute, Easylighting will can be found in

network list again.(P7.P8)

smart phone. There will be a message saying

"wireless device not found" - click OK.

the WiFi LED controller." (P1)

Continued on next page

.(P1)

[email protected]