AllPondSolutions 500-HO+ 매뉴얼 - 페이지 2
{카테고리_이름} AllPondSolutions 500-HO+에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions 500-HO+ 17 페이지. Aquarium hang-on filter with uv
페이지 인쇄To ensure your new hang on filter is set up and running correctly, and to prevent
any accidental damage or injury, please read and follow the below instructions
carefully before using your product.
SAFETY
Important!
Disconnect the mains electricity supply before attempting any
installation / maintenance of any kind. Do not attempt to modify this unit in
any way and only use the recommended parts for replacement.
The hang on filter should never be run dry as this will cause the unit to
·
overheat and cause permanent damage.
All connections must be earthed.
·
The power cord of this appliance cannot be replaced; if the cord is
·
damaged, the appliance should be discarded. Never cut the cord.
Do not connect to any voltage other than that stated.
·
This filter is suitable for indoor household aquariums only (do not use in
·
exterior locations, swimming pools, ponds, bathrooms etc). Do not place in
liquids other than water.
Do not use with water above 90F or 30C.
·
Do not carry or pull the unit by its electrical cable.
·
Do not use this unit if it has a damaged cord or plug, if it is malfunctioning
·
or it is dropped or damaged in any manner
Do not yank cord to pull plug from outlet. Grasp the plug and pull to
·
disconnect. Always unplug an appliance from an outlet when not in use.
Do not attempt to modify this unit in any way and only use the
·
recommended parts for replacement.
Before installing, maintaining or handling your equipment, or before placing
·
your hands in your aquarium, ensure that the unit is disconnected from the
electricity supply.
Always unplug any electrical devices when not in use.
·
Carefully examine your filter after installation. Do not plug in the unit to the
·
mains if there is water on any parts not intended to be wet.