ALLPOWER SupaSwift 635 LITTLE BOB 사용 설명서 - 페이지 6
{카테고리_이름} ALLPOWER SupaSwift 635 LITTLE BOB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLPOWER SupaSwift 635 LITTLE BOB 10 페이지. 18”, 21”
페이지 인쇄ENGINE STARTING PROCEDURE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
1.
Fill the engine with fuel and oil as per the engine manufacturer's instructions.
2.
Ensure catcher is fitted correctly (
3.
Check the height adjustment is set correctly for the mowing conditions you are about to encounter
(
refer to OPERATING PROCEDURE
4.
Start the engine in accordance with the engine manufacturer's instructions.
5.
Allow the engine to warm up for several minutes.
6.
Run the engine at maximum throttle setting.
7.
NB. Some models may have a fixed throttle. Please refer to the engine owners
manual for the configuration of your machine.
1.
Adjust the throttle control to the slow position.
2.
Switch the engine off.
Allow all moving parts to come to a complete stop before transporting or storing the unit.
The Supaswift Lawn Mower has 12 height positions. Positions are indicated
by the holes in the Quadrant plate (1) which mesh with the pin on the height
adjuster leaver (2). Position 1 is a travel position and must not be used for
mowing. In this position the mower blades are too low to cut grass and
damage may result. Please refer to the table below for more information.
Tip: Remember grass is a living plant and requires its leaves to live.
The leaves are what you cut and by cutting too low can result in killing
of your grass and a poor finish. This can also cause premature wear
and damage to your lawn mower.
RESULT DESIRED
1.5cm
2cm
2.5cm
3.5cm
3cm
refer to OPERATING PROCEDURE
).
SHUTTING DOWN THE MACHINE
HEIGHT ADJUSTER POSITION
HEIGHT ADJUSTMENT TABLE
HEIGHT ADJUSTER
POSITION
2
3
4
7
6
CAUTION: Read the Engine Manufacturers
Operators Manual for detailed starting
instructions
).
RESULT DESIRED
4cm
4.5cm
5cm
5.5cm
6cm
Image 4
HEIGHT ADJUSTER
POSITION
8
9
10
11
12
P a g e
| 6