Miller Auto Deltaweld 452 소유자 매뉴얼 - 페이지 24

{카테고리_이름} Miller Auto Deltaweld 452에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Auto Deltaweld 452 40 페이지. 60 hz, 50/60 hz arc welding power source
Miller Auto Deltaweld 452에 대해서도 마찬가지입니다: 소유자 매뉴얼 (30 페이지), 소유자 매뉴얼 (42 페이지)

페이지 인쇄
Miller Auto Deltaweld 452 소유자 매뉴얼

5-6. Connecting Weld Output Cables

1
Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
.
Do not place anything between weld

5-7. Remote 14 Receptacle RC8

OM-223 Page 18
.
A complete Parts List is available at www.MillerWelds.com
6
3
4
5
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1
Correct Weld Cable Connection
2
Incorrect weld Cable Connection
3
Weld Output Terminal
4
Supplied Weld Output Terminal Nut
A
J
K
I
B
C L N
H
M
D
G
F
E
2
5
Weld Cable Terminal
6
Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar.
!
1
Connect feeder to RC8.
1
803 778-B
connecting weld output cables 3−2010
Turn off power before con-
necting to receptacle.
Remote 14 Receptacle RC8
Ref. 800 166-D / Ref. S-0004-A