Miller ArcStation 소유자 매뉴얼 - 페이지 10
{카테고리_이름} Miller ArcStation에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ArcStation 20 페이지.
Miller ArcStation에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지)
페이지 인쇄
3-4. Installing Dust Tray
2
OM-247318 Page 6
2
1
AA and ZZ
Side View
1
Dust Tray Rails
Use the supplied four bolts AA and
four locknuts ZZ and install dust
tray rails to the welding table. Be
sure that dust tray rails are on the
inside of the subframe assemblies.
Tighten all bolts and locknuts.
2
Dust Tray
Install dust tray into rail slides as
follows:
Tilt rear of tray down and lift front of
tray up.
Place flange on rear of tray behind
angle iron support.
Lower
front
of
tray
until
approximately level.
Slide tray into position.
Tools Needed:
1/2 in.
hex bit 3/16 in.