ABB FIO-01 빠른 매뉴얼 - 페이지 3

{카테고리_이름} ABB FIO-01에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB FIO-01 14 페이지. Digital i/o extension
ABB FIO-01에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지)

Quick guide - FIO-01

Introduction

This manual contains the very basic information about installing the

FIO-01 Digital I/O Extension. For complete documentation refer to

FIO-01 Digital I/O Extension User's Manual (3AFE68784921

Safety instructions

WARNING! All electrical installation and maintenance work on the drive

must be carried out by qualified electricians only.

The drive and adjoining equipment must be properly earthed.

Do not attempt any work on a powered drive. After switching off the

mains, always allow the intermediate circuit capacitors to discharge for

5 minutes before working on the frequency converter, the motor or the

motor cable. Check (with a voltage tester) that the drive is in fact

discharged before beginning work.

These warnings are intended for all who work on the drive. Ignoring the

instructions can cause physical injury or death, or damage the

equipment.

For complete safety instructions see the drive manuals.

Mounting

WARNING! Before installation, do the electrical safety precautions in

section

Numbers in brackets refer to the layout drawing in section

(Page 6).

1. Pull out the locking tab (5).

2. Insert the module carefully into the option slot until the retaining clips

lock the module into position. Option slots are located on the drive

control unit.

3. Push in the locking tab (5).

4. Tighten the grounding screw (2) to a torque of 0.5 N·m (4 lbf·in).

Safety instructions (Page

3).

[English]).

Layout

Quick guide - FIO-01