ABB FIO-01 빠른 매뉴얼 - 페이지 4

{카테고리_이름} ABB FIO-01에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB FIO-01 14 페이지. Digital i/o extension
ABB FIO-01에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지)

If you need to remove the adapter module after it has been installed into

the drive, use a suitable tool (e.g. small pliers) to carefully pull out the

locking tab. Then loosen the screw and pull out the module.

Note: The screw tightens the connections and grounds the module. It is

essential for fulfilling the EMC requirements and for proper operation of

the module.

Terminal designations

Marking

X61, X62, X63,

X64

X65, X66

Wiring

Use max. 1.5 mm

conductors for the relay outputs. Ground the cable shield at the drive

end to a signal ground terminal. Refer to hardware manual of the drive or

unit for more information.

Do not route signal cables parallel to power cables.

Tighten the digital I/O signal wiring to 0.3 N·m and the relay output

wiring to 0.5 N·m.

Quick guide - FIO-01

Description

Digital inputs or outputs. Drive parameters

select signal type and use in control

program.

DIOx

• Input: 24 V, "0" < 5 V, "1">15 V.

COM

• Output: Current sink is 500 mA. If more

than two digital outputs are used, current

source is 25 mA. Otherwise current source

is 50 mA.

ROxNO

ROxCOM

ROxNC

conductors for the digital signals and max. 2.5 mm

Relay outputs:

• max. 240 VAC, 2 A resistive load

• max. 30 VDC, 5 A resistive load

Inbuilt varistors for inductive load

protection.