ABB G391 Series 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} ABB G391 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB G391 Series 13 페이지. Edge ac short circuit current limiter
페이지 인쇄
QUICK START GUIDE
Information – Tools Required
Regulations, standards, site engineering instructions etc. take precedence over these general installation instruc-
tions.
•
Steel toe safety shoes
•
Torque wrench - 0-65 in-lb (0-10 Nm) and 40 ft-lbs
•
Volt Meter for Lock-Out Tag-Out procedures
Check for deliveries:
Make sure that the box contains the
•
8x #6-32 Screws (CC408578537)
•
6x 60A Fuses (4600482350P)
•
6x Fuse Covers (4600480552P)
9x #4-40 Nuts (CC408578388)
•
Cabinet Top
The top of the Edge cabinet is shown here. The relevant areas are noted:
1.
AC input panel which contains two twist-n-lock AC input receptacles for AC input power.
2. Center back panel to be removed and replaced with Edge AC current limiter G391 assembly.
AC input panel
with two
twist-n-lock
receptacles
Page 8
© 2023 ABB. All rights reserved.
•
Sockets - as needed for mounting hardware
•
Screwdrivers - #2 pozi drive screwdriver. Flat and Torx bit
set with security pin
Two AC input
cords with
twist-n-lock
Center-Back Panel
plugs
Figure 4 Cabinet top
Edge_Ilim_G391_QSG
Version. 2.0