Panasonic WV-SC384 설치 매뉴얼 - 페이지 15

{카테고리_이름} Panasonic WV-SC384에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SC384 40 페이지. Ip video cameras
Panasonic WV-SC384에 대해서도 마찬가지입니다: 설치 매뉴얼 (40 페이지), 사양 (2 페이지), 설치 매뉴얼 (40 페이지), 통합 참고 사항 (8 페이지)

페이지 인쇄

Installations/Connections

Caution:

• ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED POWER SOURCE (IEC

UL/CSA 60950-1).

This camera is designed to be installed on a ceiling.

Before starting the installation/connection, prepare the required devices and cables.

Before starting the connection, turn off the power of the devices including the camera and the PC or disconnect from the

12 V DC power supply.

Install

When installing the camera on a ceiling, there are two methods; wiring through a hole in the ceiling (☞ page 16) and wiring

through a cable guide (unnecessary to make a hole in the ceiling) (☞ page 20).

Important:

• Procure 4 screws (M4 or M6) to secure the camera mount bracket (accessory) to the ceiling according to the material

of the installation area. In this case, wood screws and nails should not be used.

When installing on concrete ceiling: Fix with anchor bolts (M6).

(Recommended tightening torque: M4: 1.6 N·m {1.18 lbf·ft}, M6: 5.0 N·m {3.69 lbf·ft})

• Required pull-out capacity of a single screw/bolt is 196 N {19.99 lbf} or more.

• If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced

or the ceiling mount bracket for the camera WV-Q105A (option), or the ceiling embedding bracket WV-Q155S/

WV-Q155C (option), shall be used.

• When using an outdoor housing to install the product on the ceiling, use the inner cover (provided with optional mount

brackets). That can avoid the shape of the camera from reflecting on images.

• When using a mount bracket (option) or inner cover (provided with optional mount brackets), refer to the operating

instructions of the bracket in use.

• Remove the cover film from the transparent part of the dome cover after the installation is complete.

• Be sure to install the safety wire to prevent a fall of the camera resulting in injury or accidents in case the mount brack-

et (accessory) comes off. (Only for models that can be installed with a safety wire)

Safety wire angle

Anchor bolt

(Procured locally)

Safety wire

Camera mount bracket

(accessory)

Roof space

WV-Q105A (option)

Mounting screws

(4 pcs, WV-Q105A supplied)

Ceiling board such as plaster board

Decorative cover (accessory)

Camera

EN/