Panasonic WV-SP105 설치 매뉴얼 - 페이지 23
{카테고리_이름} Panasonic WV-SP105에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SP105 36 페이지. Ip video cameras
Panasonic WV-SP105에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (2 페이지), 데이터시트 (2 페이지), 비교 차트 (6 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
Connection
Caution:
• FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
z
Connect a LAN cable (category 5 or better) to the
network connector on the rear of the camera.
x
Connect the power cord.
Important:
• The 12 V DC power supply shall be insulated from the commercial AC power.
When using 12 V DC power supply*
●
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm - 7 mm {1/8" to 9/32"} from the end of the
wire, and twist the stripped part of the wire sufficiently to
avoid short circuit.
Specification of cable (wire): 16 AWG - 28 AWG,
Single core, twisted
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug (accessory).
r Connect the power cord plug (accessory) to the 12 V DC
power supply terminal on the rear of the camera.
* FOR UL LISED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
12V IN
LAN cable
ACT
LINK
(This illustration
represents WV-SP105.)
12V IN
To 12 V DC
power supply
ACT
LINK
(This illustration
represents WV-SP105.)
12 V DC power
cord plug
(accessory)
(GND)
INITIAL
SET
POWER
INITIAL
SET
POWER
(12 V DC)
23