Panasonic WV-SW316L 설치 매뉴얼 - 페이지 22

{카테고리_이름} Panasonic WV-SW316L에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SW316L 50 페이지. Ip video cameras
Panasonic WV-SW316L에 대해서도 마찬가지입니다: 사양 (2 페이지), 통합 참고 사항 (8 페이지)

페이지 인쇄

Connect the alarm input/output cable.

Terminal name

ALARM OUT, AUX OUT

Open

ALARM IN, DAY/NIGHT IN Non-voltage make contact input (4 V DC - 5 V DC, internally pulled

OFF

Note:

• Check if rating of an external device such as a sensor is applicable to the rating of this product

by referring to the provided operating instructions.

Speciﬁcation of 4P alarm cable (accessory)

Connect a LAN cable (category 5e or better, straight, STP*) to the network connector.

* E model only

Connect the power cable.

• When using 12 V DC power supply*

Connect the output cable of the AC adaptor to the 2P power cable.

• When using PoE (IEEE802.3af compliant)

Connect a LAN cable (category 5 or better, straight, STP*

hub) and the network connector of the camera.

*1 FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.

*2 E model only

IMPORTANT:

• Use all 4 pairs (8 pins) of the LAN cable.

• The maximum cable length is 100 m {328 feet}.

• Make sure that the PoE device in use is compliant with IEEE802.3af standard.

• When connecting both the 12 V DC power supply and the PoE device for power supply, PoE

will be used for power supply.

• When the LAN cable is disconnected once, reconnect the cable after about 2 seconds. When

the cable is quickly reconnected, the power may not be supplied from the PoE device.

SW316L

Ratings

Open collector output (maximum applied voltage: 20 V DC)

4 V DC - 5 V DC by internal pull-up

Output voltage 1 V DC or less (50 mA or less)

up)

Open or 4 V DC - 5 V DC

Make contact with GND (required drive current: 1 mA or more)

GND (black)

AUX OUT (gray) (Terminal 3)

ALARM OUT (red) (Terminal 2)

ALARM IN, DAY/NIGHT IN (green) (Terminal 1)

SW316L

SW316

) between a PoE device (such as a