Panasonic DMC-FX07PL 서비스 매뉴얼 - 페이지 24

{카테고리_이름} Panasonic DMC-FX07PL에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic DMC-FX07PL 50 페이지.

8.3.8.

Removal of the Sub P.C.B.

8.3.9.

Removal of the Battery Case

NOTE: (When Assembling)

Be sure to confirm the following points when assembling.

• The Screw is tightened enough.

• Assembling conditions are fine. (No distortion, no illegal-

space.)

• No dust and/or dirt on every Lens surfaces.

• LCD image is fine. (No dust and dirt on it, and no gradient

images.)

Fig. D9

Fig. D10

8.4.

Disassembly Procedure for the

Lens

NOTE: When Disassembling and Assembling for the Lens

1. To minimize the possibility of the CCD being dirt, perform

disassemble and/or assemble under the condition of the

CCD is being mounted.

Disassembling procedures for the CCD unit, refer to item

8.6.

2. Take care that the dust and dirt are not entered into the

lens.

In case of the dust is putted on the lens, blow off them by

airbrush.

3. Do not touch the surface of lens.

4. Use lens cleaning KIT (BK)(VFK1900BK).

5. Apply the grease (VFK1829) to the point where is shown

to" Grease apply" in the figure.

When the grease is applied, use a toothpick and apply

thinly.

8.4.1.

Zoom Motor Unit, Master Frange

Unit, Drive/Direct Frame Unit and

1st Lens Frame/2nd Lens Frame

Move Unit

1. Unscrew the 4 screws (A).

2. Remove the zoom motor unit to the indicated by arrow.

3. Remove the master frange unit to the indicated by arrow.