Aquatic 260304PSL/R 설치 데이터 - 페이지 5

{카테고리_이름} Aquatic 260304PSL/R에 대한 설치 데이터을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatic 260304PSL/R 8 페이지.

Installation Data

160304PSL/R, 160304PSML/R,

260304PSL/R, 260304PSML/R

Fax on Demand # 9034

Installation Instructions

12 12

13 13

Measure the distance between the top of the back horizontal flange and the bottom of the pan

Fasten a 1" x 3" (25mm x 75mm) ledger strip along rear of alcove and

ledge, approximately 1-1/2" (40mm). Mark this dimension on the back studs (or wall), below

along both sides (immidiately below the lower marks made on framing).

the first mark.

14 14

15 15

Install drain assembly per manufacturer's instructions. (Optional) Mix foundation material. Place three or four

Place base into framing pocket.

mounds on the subfloor around but away from drain hole. The mounds should be placed high enough so that when

the unit is set, it will cause the plaster to displace and spread.

16 16

17 17

Tap down until level. Level lengthwise and widthwise using 3 ft. (915mm)

Pre-drill horizontal flanges along top of base section and fasten into each corresponding stud.

level by shimming or depressing foundation materials.

Pre-drill both (vertical) side flanges and fasten to side studs 8" (200mm) on center.

The unit must be set level. Apron should be firmly on the floor.

Place cardboard to protect finish.

Aquatic Bath • 8101 E. Kaiser Blvd., Anaheim, CA • (800) 945-2726 • www.aquaticbath.com

— 5 —