Aquatic Digital Media Locker AQ-DM-6BT 사용자 및 설치 매뉴얼 - 페이지 5

{카테고리_이름} Aquatic Digital Media Locker AQ-DM-6BT에 대한 사용자 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatic Digital Media Locker AQ-DM-6BT 15 페이지. Digital media locker for bluetooth & mp3 devices
Aquatic Digital Media Locker AQ-DM-6BT에 대해서도 마찬가지입니다: 사용자 및 설치 매뉴얼 (16 페이지)

페이지 인쇄

Getting Started

Digital Media Locker AQ-DM-6BT

1.4. Mounting the Digital Media Locker

1. A mounting template is included.

26mm

65mm

Aquatic AV recommends using the 'measure

twice, cut once' method.

2. Once the mounting hole is complete,

make sure the outside surface is clean and

clear of debris. The Digital Media Locker

has an external water/dust proof gasket, but

this requires a clean and flat surface for

best performance.

3. The Digital Media Locker has six (6)

front screws. Drive the screws using a screw

driver. During final mounting, apply equal

pressure to all points for the best water/

dust outer seal performance. make sure

screws are snug and do not over tighten.

4. Review all outside surfaces of the Digi-

tal Media Locker to ensure proper water/

dust seal. This is important for long term

environmental protection performance for

your digital media device.

120mm

1.5 Bluetooth Antenna Installation

1. Screw on the provided Bluetooth Antenna,

avoiding bending the cable at a 90° angle.

2. Install the Bluetooth antenna as high as

possible, above the waterline of the spa if possible,

and making sure the arrow is pointing directly

upwards towards the sky to ensure the Bluetooth

range is maximized. If there is no suitable surface

to screw it in, we recommend using a good quality

double sided tape.