Aquatic Digital Media Locker AQ-DM-6BT 사용자 및 설치 매뉴얼 - 페이지 6

{카테고리_이름} Aquatic Digital Media Locker AQ-DM-6BT에 대한 사용자 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatic Digital Media Locker AQ-DM-6BT 15 페이지. Digital media locker for bluetooth & mp3 devices
Aquatic Digital Media Locker AQ-DM-6BT에 대해서도 마찬가지입니다: 사용자 및 설치 매뉴얼 (16 페이지)

페이지 인쇄

Getting Started

1.6 Power On

Press the ON/OFF button.

Red Light: Power to the docking station is ON, but the unit is in standby mode.

Blue Light: The unit is powered ON and looking for an audio source.

For applications that require low current draw and where battery drain may occur, the power but-

ton must be turned OFF inside the unit. When the power button is in the OFF position the red

LED will not be lit.

For applications where a 12V battery is not used, such as in a Spa, the power button can be left

ON and the remote control or door controls can then be used to power on/off accordingly.

For detailed instructions you can check out our online video:

1.7 Handheld Remote Control Charging

The optional remote AQ-RF-6UBT-T (sold separately) has a built-in Polymer Lithium re-

chargeable battery and comes with a charging cable. Connect one end of the charging cable

to the charging connection on remote control and connect the USB end of thje charging

cable to any USB charger (5V DC) for charging.

Make sure the remote has been charged before used.

1.8 Handheld Remote Control Synchronizing

The AQ-RF-6UBT-T remote (sold separately) has a receiver module (AQ-RF-6UBT-R) with a

built-in male DIN connector. Connect the receiver module's DIN connection to the female

DIN connector of the Digital Media Locker.

The remote should already be paired from the factory, but if you need to synchronize the

remote, follow the steps below.

1. Make sure Digital Media Locker is powered ON (red LED) 2. Put the remote within 0.5

meter of the Digital Media Locker.

2. Press and hold MODE on remote control until the LCD shows "Pairing in Progress". Re-

lease the button.

3. Within 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show "Retry

again". If this happens, wait 5 seconds and repeat steps above.

For any additional remote controls, you will also need to synchronize those remote controls to

the Digital Media Locker.

If the pairing process is not successful, try again to put your remote close to the remote receiver.

Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD

shows nothing, the battery has been drained and will need charging.

If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the

new remote control.

www.aquaticav.com

'How to wire your Aquatic AV stereo system'

http://www.aquaticav.com/support/videos

Digital Media Locker AQ-DM-6BT