Aquatic Access IGAT-90 설치 매뉴얼 - 페이지 5

{카테고리_이름} Aquatic Access IGAT-90에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatic Access IGAT-90 18 페이지. Pool lift

Aquatic Access Model IGAT-90

The customer and installer are responsible for assuring the strength of the mounting for the pool

lift and for determining if grounding the unit is necessary. These installation instruction must be

followed to meet advertised lifting capacities.

The customer or installer and Aquatic

Access mutually agree upon the socket

location. Usually, the customer provides

Aquatic Access with a drawing showing the

measurements and configuration of the deck,

coping, gutter, and pool wall. This allows

our engineers to determine the best location

for the socket. The pool lift should normally

be located where there is at least 36" of

straight vertical pool wall. The depth would

need to be greater if there is a curve instead

of a right angle at the pool bottom. The depth range of 42"– 48" (deck to pool floor) is ideal.

(IN-GROUND AUTOMATIC-TURN OF 90°)

INSTALLATION

It is recommended that the lift be installed 48"

(minimum 36") from inside pool corners and ladders

that could interfere with the turn of the seat. The

socket should not be placed directly on an expansion

joint, but at least 4" away from it. If unsure about the

measurements, configurations or structural integrity,

have a local contractor verify them.

If you have received the socket in advance of the lift

without instructions as to how far away from the pool

edge to install the socket, or if any questions remain,

consult with the engineers at Aquatic Access before

installing the socket.