Aquatic Life 540502 설치, 운영, 유지보수 매뉴얼 - 페이지 5

{카테고리_이름} Aquatic Life 540502에 대한 설치, 운영, 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatic Life 540502 10 페이지. Single and dual deionization systems

INSTALLING THE CARTRIDGES

Step 1 - Use the Canister Wrench in a clock-wise direction to gain access to the Deionization Cartridges.

For proper operation, the water must flow into the right canister first and water flows out of the left

canister.

NOTE: Use care to center the cartridges in the middle of each Canister prior to re-attaching the

Canisters.

INSTALLING THE TDS METER (MODELS 540502 & 540503 ONLY)

A TDS Meter is included with the DI Filtration Unit. Refer to the Instructions included with the Meter for

operation. The TDS Meter is capable of measuring the TDS from two different points in your filtration

system. We recommend you place one probe prior to the water entering the DI Filtration Unit and the

other probe where the water exits the DI Filtration Unit – photos on next page show how to connect.

Measure Point 1

Most RO Units remove 95 -98% of the TDS from your water. The TDS Meter will allow you to

monitor the TDS of Membrane filtered water so you know when it's time to replace your

Membrane.

Measure Point 2

Connecting one of the TDS Meter probes to the water line exiting the DI Filtration Unit will allow

you to monitor if the DI Resin is completely exhausted. When you see the TDS rise above zero,

you will know it's time to replace the resin in the cartridge.