DIAVITE AG DIAVITE Compact VH 매뉴얼 - 페이지 14
{카테고리_이름} DIAVITE AG DIAVITE Compact VH에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIAVITE AG DIAVITE Compact VH 14 페이지.
페이지 인쇄
4.2
Malfunctions
The DIAVITE COMPACT has been constructed for workshop use. The tracers are, however, very
delicate and susceptible to damages. They should not be exposed to mechanical strain. If, when
putting a tracer with skid onto a flat surface, the green control LED does not start to flash up, the tracer
could be damaged. If possible, check the instrument with a second tracer or send the complete
instrument to the dealer for a check.
4.3
Repairs
Repairs are to be effected by the manufacturer only.
Upon written request, a repair cost estimate will be submitted. The necessary efforts for controlling,
partially dismantling of parts, inspection time as well as an adequate share for administration effort,
and transport costs, must be paid by the customer in any case, even if the estimate of cost is rejected
by the customer.
80% of the repairs concern the standard tracer SH (dirt, oil, break of diamond point and suspension). It
is recommended to buy a spare standard tracer.
4.4
Guarantee
The guarantee is valid for one year after factory dispatch and is applicable to damage caused by parts
of proved insufficient quality. The guarantee does not cover damages of the diamond tip and the
rechargeable batteries, nor malfunctions due to mechanical damages, such as break of suspension,
bending or breaking of parts (which are delicate due to their nature of construction), nor damages
caused by non-observation of the working instructions, or damages caused by insufficient packing for
transport back to the factory. Parts to be replaced must be sent back to the factory.
4.5
Referenced Documents
EN ISO 3274
EN ISO 4287
EN ISO 4288
En ISO 11562
EN ISO 12085
EN ISO 13565-1
EN ISO 13565-2
DIAVITE COMPACT
(Basis documents in German language)
Nenneigenschaften von Tastschnittgeräten (1998)
Oberflächenbeschaffenheit: Tastschnittverfahren (1998)
Regeln und Verfahren für die Beurteilung der Oberflächenbeschaffenheit
(1997)
Oberflächenmesstechnik:
Tastschnittgeräten - Phasenkorrekte Filter (1998)
Geometrische Produktspezifikationen (GPS) – Oberflächenbeschaffenheit:
Tastschnittverfahren – Motif-Kenngrössen (1996)
Filterung und allgemeine Messbedingungen (1998)
Beschreibung der Höhe mittels linearer Darstellung der Materialanteilkurve
(1998)
Profilfilter
zur
Anwendung
13
in
elektrischen