HTC 420 VS 사용자 설명서 - 페이지 28
{카테고리_이름} HTC 420 VS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 420 VS 46 페이지. Floor grinder | concrete floor sander
HTC 420 VS에 대해서도 마찬가지입니다: 매뉴얼 (50 페이지)
페이지 인쇄Operation
Warning!
Only cold water with no chemical additives may be used.
5.
4.7. Control
The machines functions can be controlled using the control panel -
see Figure 3-3 on page 11.
During operation, the operator pushes the grinder forward over the
floor surface.
4.7.1. Standby
In order to activate the machines functions, turn thePowerknob
to"I".Once the knob set to this position, the Power indicator on the
control panel lights up, indicating that the machine is in stand by
mode.
4.7.2. Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an
emergency.
When the switch is pressed, all electrically-operated equipment in
the machine is turned off.
Note!
Do not use the emergency stop switch to stop the machine other
than in emergencies, as it causes wear to the contactor.
Note!
As long as the emergency stop switch (EM-Stop) is pressed, the
machine cannot be started. Reset by turning the switch 45° so that
it pops out again. The machine can then be restarted.
4.7.3. Starting the machine
For a description of the control panel, see Figure 3-3 on page 11.
1.
20
Fill the tank with cold water.
Insert the cord.
HTC 420 VS
3.0