Olympus CX-DO 사용 설명서 - 페이지 8

{카테고리_이름} Olympus CX-DO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus CX-DO 13 페이지. Dual-viewing attachment

CX-DO

Fig. 6

The cords are vulnerable

when bent or twisted.

Never subject

them to excessive

force.

AMIC

a e sure that the main switch

is turned

to OFF before

connecting

the power cord.

1. Connect the pointer illumination cord plug @ to the connector @ on

the rear panel of the TDO transformer.

2. Connect the power cord plug @ to the wall outlet.

Fig. 7

1. Loosen the support pillar clamping knob @ and thread the upper section

@ of the support pillar into the socket @ located at the underside of

the secondary observer position on the dual-viewing

body.

2. Extend the lower section of the support pillar until the base is in contact

with the table surface.

* The dual-viewing

body should be parallel with the table surface.

3. Clamp the support pillar by tightening the support pillar clamping knob