Alphasonik AS268P 매뉴얼 - 페이지 7

{카테고리_이름} Alphasonik AS268P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alphasonik AS268P 16 페이지. Full range speakers

NOTE: Alphasonik strongly recommends that you operate your system at

low volume prior to the completed installation of your Alphasonik speakers.

This will allow a test of the speaker before securing it to its permanent

location.

CAUTION: Make sure that all speaker wiring is fully protected from cuts,

tears and possible wear. Any short circuit developing as a result could

severely damage the source unit or possibly the amplifier. Make sure all

speaker wires easily reach the speaker terminal with no stress on the wires

or connectors.

MOUNTING

1. Confirm the mounting location and depth requirements by inspecting the

area where the speaker will be mounted. Most speakers will fit into stock

locations on the vehicle, in this case only depth is important.

2. If the location you have picked does require cutting, use the hole cutout

measurement from page 4 and mark the mounting location.

3. If there is a cosmetic panel where the speaker will be mounted, we

recommend using a utility knife to carefully cut a hole in it. Confirm the

cut by placing the speaker in the hole. You may modify the hole as

necessary.

4. If it will be necessary to cut steel, reinstall the cosmetic panel in place

and use the hole you have previously cut as a template. This will help

to insure proper cutting and a good fit. Mark the location for the speaker

mounting screws, remove the panel and drill the screw holes. When

finished you may replace the panel.

After cutting and drilling all holes, inspect the mounting areas for any

metal burrs or rough edges. File any area that may interfere with the

mounting of the speaker.

6. Clean any metal shavings from the mounting area and check for areas

in which water may enter the speaker cavity. Treat the area for water

protection when necessary.