ABB ACS320 series 설치 지침

{카테고리_이름} ABB ACS320 series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS320 series 4 페이지. Variable frequency drives in renewaire ventilators
ABB ACS320 series에 대해서도 마찬가지입니다: 보충 설명서 (16 페이지), 설치 지침 (4 페이지)

페이지 인쇄

ACS150, ACS310, ACS320, ACS350 and ACS355

MUL1-R1 Installation instructions

WARNING! Before installing MUL1-R1

option, read the safety instructions and

mechanical and electrical installation

instructions in the drive user's manual.

Follow the instructions when installing,

operating and servicing the drive. If

ignored, physical injury or death may

follow, or damage may occur to the

drive, motor or driven equipment.

drive motor or driven equipment

Note: You cannot lead the Safe torque off (STO) cable

through the gland plate in the ACS355.

3. Install clamps (3a) for control cables (see power cable

lead-throughs), or if cables are run in conduits, replace all

clamps with suitable glands (not included). Run cables

through the clamps and tighten. Strip cable ends. Fasten

the grounding conductor (PE) of the input power cable and

the twisted shield of motor cable under the grounding

clamps (3b). Connect the conductors to appropriate

terminals. See Electrical installation in the drive manual.

1. Fasten the gland box frame to drive with two M4×12

screws.

4. With FPBA-01 or FCAN-01 option modules, remove the

detachable lid (4) from the gland box cover.

This datasheet has been downloaded from

2. Fasten the gland box frame to wall with four M4 screws

(not included).

5, 6, 7. With any fieldbus option module except FRSA-00,

remove the support plate (5), install the I/O clamping plate

remove the support plate (5) install the I/O clamping plate

(6) and the option grounding plate (7) to the gland box

frame. See Mechanical installation in the drive manual.

http://www.digchip.com

at this

page

3AFE68642868 Rev. E / 2010-01-25