ABB ATS Annunciator 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} ABB ATS Annunciator에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ATS Annunciator 12 페이지. Modbus; ats annunciator monitors and controls up to 8 automatic transfer switches equipped with the mx150/250 controller.

페이지 인쇄

—

Information

—

MODBUS Device IDs

Each device on a MODBUS Network must have a unique ID.

Non-unique IDs cause communications conflicts and must be resolved. See Troubleshooting.

ATS IDs are set in the ATS MODBUS interface.

Annunciator IDs are set via the ATS Annunciator Tool (Step 6).

—

Factory reset

Factory default settings are Annunciator ID=1 (

Press and hold Factory Reset and Firmware Update switch until the Status LED turns red (5 seconds) -

The Status LED will be green when Reset is complete.

—

Firmware Update

1. Download the Remote Upgrade Program to the PC - See Reference Documents.

2. Press and release Factory Reset and Firmware Update switch until the Status LED turns red (5 seconds) -

Step 4. The Status LED will blink red.

3. Run the Remote Upgrade Program on the PC.

a. Establish communications with the Annunciator.

b. Follow instructions as presented by the Remote Upgrade Program.

The Status LED will be green when upgrade is complete.

It may be necessary to press and release S2 to exit the programming mode.

in Step 6) in and no configured ATS (

in Step 6 all "None").

in figure in Step 4.

in figure in