ABB Contrac PME120AI 사용 설명서 - 페이지 9

{카테고리_이름} ABB Contrac PME120AI에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB Contrac PME120AI 20 페이지. Electrical part-turn actuator
ABB Contrac PME120AI에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)

페이지 인쇄

7.4

Mounting the actuator to the valve

7.4.1

Preparing the equipment

IMPORTANT - Make sure that the shaft and lever bore surface are clean and free of grease.

- Determine the length of the stay tube (not included in the scope of delivery).

- Move the valve to the "CLOSED" position.

- Move the actuator to the corresponding end position using the handwheel. Observe the permissi-

ble angle.

- Spacing "L" minus 140 mm yields the required length of the link tube.

- Drill a cone bore into the valve lever for mounting the second ball-and-socket joint, as shown in

Figure 4.

- Insert the ball-and-socket joint, secure with crown nut and split-pin.

- Remove the welding bushings and weld them to the stay tube (C 15 to DIN 17210)

- Insert the link rod between the two ball-and-socket joints and screw it in.

- If required adjust "L" by turning the link rod.

- When all adjustment steps are finished, fasten the counter nuts.

7.4.2

Adjusting the stops in dependence of the travel

- Move the output lever / valve to the position requiring fine adjustment.

- Put the stop onto the toothing as close to the output lever as possible and fasten with screws.

- Move the output lever towards the stop using the handwheel; turn the coupling rod for fine adjust-

ment.

- Fasten the counter nuts.

- Fasten the stop in the other mounting position close to the end position, depending on the tooth-

ing.

7.4.3

Adjusting the stops in dependence of the torque

- First proceed as described above for travel-dependent adjustment.

- Prior to re-fastening the counter-nut lock the handwheel and then turn the coupling rod in such a

way that an initial tension occurs in the valve's closing position.

- Fasten the counter-nuts.

rigid, vibration-free

support

Fig. 2:

Mounting PME 120, example

α ≥ 15 °;

A68-2005-003 EN

Electrical Part Turn Actuators for Continuous Modulating Control PME120AI (Contrac)

tightening torque for limit stop screws: 46 Nm

echanical

limit stop

coupling

flap

lever

according to dimensions specified by the valve manufacturer

lever

boring diameter for

fastening screws: 12 mm

tensile strength:

≥ 400 Nm

tightening torque for

lever clamping screw:

23 Nm

Mounting

r00304e1