ABB mFLO Series 시작 매뉴얼 - 페이지 8

{카테고리_이름} ABB mFLO Series에 대한 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB mFLO Series 20 페이지.

페이지 인쇄

Solar Panel Installation

Totalflow

Materials

Supplied

Customer

Materials

Supplied

Procedure:

Note: Step 1 and 2 are not required if pipe is tall enough without the

extension.

1. Attach 2-inch pipe collar to top end of

Securely tighten. (See Figure 4)

2. Install a 2-inch pipe extension into collar and securely tighten.

3. Install Solar Panel on mounting bracket with provided hardware.

4. Attach Solar Panel mounting plate to top end of 2-inch pipe with U-

bolts and associated mounting hardware. Do not tighten U-bolts until

Solar Panel has been correctly oriented.

5. If needed, connect Solar Panel power cable to Solar Panel connector

on back of unit. DO NOT connect the other end of cable to

unit until all steps are complete AND main battery pack has been

connected.

6. Position Solar Panel to face south in the northern hemisphere and

north in the southern hemisphere. Tighten U-bolts securely to avoid

movement by wind or vibration.

7. Check solar panel polarity using digital voltmeter to insure (+) and (-)

wires are properly identified.

8. The Solar Panel power cable connects to terminal block J7 Charger

Input terminals (See Figure 5). Remove one of the hole plugs from

the

FLO enclosure and install cord connector. Remove nut,

sealing ring and rubber grommet from cord connector. Slide nut,

sealing ring and grommet over cable and insert cable through body

of cord connector. Allow enough power cable to extend into the unit

for connection to Charger Input +/- terminals.

9. Secure Solar Panel cable using grommet, sealing ring and nut.

TIP:

To prevent moisture from entering the

"dip" below, and then rise to access hole. This will provide a path

for rainwater away from the access hole.

•

One Solar Panel and Cable

•

Two U-Bolts and fastening hardware

•

One Solar Panel Bracket

•

Cable Ties

•

One 9-inch or greater extension of 2-inch pipe

•

One 2-inch collar

FLO mounting pipe.

FLO, allow cable to

FLO