Epson 220 매뉴얼 - 페이지 20

{카테고리_이름} Epson 220에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 220 29 페이지. Epson printer parts manual

페이지 인쇄

EPSON LQ-2080

Removing paper from the pull tractor

1. After you finish printing, tear off the of paper at the

perforation nearest the paper entry slot.

tear off

here

2. Hold down the

button to eject the paper from

LF/FF

the printer.

Using two tractors in a push and pull combination

You can use two tractors at the same time to reduce paper

jams and improve continuous paper feeding. You can load

paper onto both the front push and pull tractors in the front

paper slot, or you can load paper onto both the rear push and

pull tractors in the rear paper slot.

To use the rear push tractor with the pull tractor, you need to

purchase the optional tractor unit (C80032*). To use the front push

and pull tractor, you need to purchase two optional pull tractors

(C80032*). Install the optional pull tractors as described in "Installing

the tractor in the front push position" on page 12 and in "Installing

the tractor in the pull position" on page 17.

Note:

The tractor in the rear push position cannot be removed.

To load paper onto two tractors, follow these steps:

1. Remove the printer cover and paper guide.

2. Make sure one tractor is in the front or rear push position

and one tractor is in the pull position. Set the paper release

lever to either the front or rear push tractor position,

depending on which tractor you use. Then set the paper

thickness lever to accommodate your paper thickness.

3. Load paper onto the front or rear push tractor you want

to use.

20 - EPSON LQ-2080

4. Turn on the printer. Press the

advance the paper to the top-of-form position. Then press

the

button until the perforation between the first and

LF/FF

second page is even with the top of the printer ribbon.

Caution:

Never use the knob to adjust the top-of-form position

while the printer is turned on; this may damage the

printer or cause it to lose the top-of-form position. The

knob can be used only when the printer is turned off.

5. Attach the paper to the pull tractor sprockets as described in

"Loading paper onto the pull tractor" on page 18.

6. Set the paper release lever to the pull tractor position. Then

remove any slack in the paper between the push and pull

tractors using the micro adjust feature, if necessary.

7. Move the paper release lever back to the push tractor

position you set in step 2.

8. Adjust the top-of-form position using the micro adjust

feature as described in "Adjusting the Top-of-Form

Position" on page 22. The printer will start printing at the

current position without advancing the paper.

Caution:

Never use the knob to remove slack in the paper or to

adjust the top-of-form position while the printer is turned

on; this may damage the printer or cause it to lose the

top-of-form position. The knob can be used only when

the printer is turned off.

Always remove any slack from the paper; otherwise

print quality may be reduced.

9. Attach the paper guide. Then slide the edge guides to the

middle of the paper guide.

10. Attach the printer cover and close the paper guide cover.

Note:

Always close the printer cover before printing. The printer does

not print when the cover is open.

11. You may need to check and change the printer driver

settings. When the printer receives data, it automatically

loads the paper and starts printing. As shown below, the

printed pages are fed over the paper guide toward the back

of the printer.

12. After you finish printing, open the paper guide cover; then

tear off the printed document at the perforation nearest the

paper exit slot.

2/99

button to

Load/Eject