Epson AP-2250 제품 지원 게시판 - 페이지 14
{카테고리_이름} Epson AP-2250에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson AP-2250 16 페이지. Product support bulletin(s)
Epson AP-2250에 대해서도 마찬가지입니다: 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (5 페이지), 제품 지원 게시판 (6 페이지)
C l h n1 n2 d, . . . dk is the command for printing control codes as data where nl
and n2 are variables and d, . ..d,representthedat&atistobeprintedas
interpreted as characters instead of control codes". Thii command is used primarily
to print displayable characters such as ASCII values 0 through 31 in Registered Tables
1 through 9 which are normally used as
T
determine the values for nl and n2 perform the following steps.
O
1. Determine how many ASCII codes will be sent sequentially immediately
following nl and n2
2 Using long division, divide the quantity of ASCII codes that will be sent
sequentially immediately following nl and n2 by 255.
3. The remainder in the quotient is the value for n1.
The whoie number in the quotient is the value for n2
4.
EXAMPLE
1. The symbols for the different suits of a card deck (hearts, diamonds, clubs,
and spades - V', +, 4, and 4) are to be printed. These are each separate
ASCII codes (ASCII codes 2 3.4, and 5 when using the PC437 Character
table).
2 4dividedby255= 0 with a remainder of 4.
3. nl =4
In the Basic programming language, the command would look like this.
Thii command, as listed in the line above, will cause the printer to print the symbols
for the different suits of a card deck (hearts, diamonds, clubs, and spades V', +, 4,
and 4). Another example of using the ESC ( * command is illustrated in the
explanation of the ESC ( t (Assign Character Table) command.
PSB No: P-0082
Page:
14 of 14
control codes (LF, FF,
ESC, etc.)