Ayce SOL-CIL998 원본 사용 설명서 - 페이지 16

{카테고리_이름} Ayce SOL-CIL998에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ayce SOL-CIL998 19 페이지. Solar flood light with pir sensor

TROBLESHOOTING:

Light does not activate in normal operation. Correction: make sure that:

1. The main unit switch is the AUTO position.

2. The Lux control is not set too far toward (

3. The motion sensor is positioned to face oncoming movement.

4. The solar cell is angled so that it gets plenty of direct sunlight for most of day, if not the entire day.

5. The bulb is broken.

6. Battery charge is not too low (charge for 3 sunny days—switch turned to OFF).

Light turns on during the day. Correction:

1. Make sure that the Lux control is not set too far toward (

Light quickly ﬂashes on and o . Correction:

1. Adjust the time setting.

2. Low battery (charge for 3 sunny days—switch turned to OFF).

Light is not as bright as normal. Correction:

1. Low battery (charge for 3 sunny days—switch turned to OFF).

Turn the TIME control knob to "-" or "+" direction to control how long the light stay on (from about 10

seconds to 1 minutes).

Remark: When the lamp is on, if a new movement is detected, the illumination time is recalculated from

the last detected movement.

Adjusting the sensitivity:

The sensitivity means the Maximum distance which PIR Sensor can be triggered by movement body

(12 meters). Turning the SENS knob from (+) to (-) will decrease the sensitivity.

The Lux control module has a built-in sensing device (photocell) that detects daylight and darkness.(

position denotes that the loading will be turned on by PIR during day and night, ( ) position denotes that

the loading will be turned on by PIR only at night. You can set to operate the unit at the desired level by

adjusting the LUX knob. Hinweis: If, in daily position, the unit turns on when it is too light outside, turn the

control towards (

bright house light, turn this control towards ( ).

). however, if the light is not activating during nighttime because of a street light or

)