Ayra TDC Cross 사용자 설명서 - 페이지 6
{카테고리_이름} Ayra TDC Cross에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ayra TDC Cross 11 페이지. Dmx led light effect with 5 lenses
페이지 인쇄
display ON. The DMX indicating dot will not turn off for convenience reasons.
Flip display: Disp
When activating this function, the LED display will flip upside-down. This might be convenient when
the fixture is installed in a certain way and you need to read the values on the display.
Channel mode: Chnd
This mode changes the DMX channel mode between 1 and 4. Each mode has its own characteristics,
which makes basic, medium or advanced control possible.
Working time: hour:
It is possible to see the total working time of this fixture, by activating this feature.
Test mode: test:
The unit will test all its internal programs.
Version: Vers
This feature is only intended for technical purposes and shows the current firmware version of the unit.
This can not be changed.
DMX control mode:
This fixture can be controlled using a DMX-controller and standard XLR male to XLR female cable.
When doing so, make sure your DMX-controller is capable of controlling your fixture. When in doubt,
contact your local dealer for advice.
Set the correct address on the digital display, you are able to choose a value between 001 and 255.
When a DMX-signal is received, a blinking red dot on the display is active.
NOTE: At some point, mirror-motors and lenses will be identified by using the numbers 1, 2, 3 and 4.
The numbers apply from left to right. The most left mirror is mirror 1, the most right mirror is mirror 4.
This unit has the following DMX-channels and DMX-values:
1 channel DMX mode
Channel 1: Pattern
Start value
End value
0
7
8
17
18
27
28
37
38
46
47
56
57
66
67
75
76
85
86
95
96
104
105
114
115
124
125
133
Function
Blackout
Chase 1
Chase 2
Chase 3
Chase 4
Chase 5
Chase 6
Chase 7
Chase 8
Chase 9
Chase 10
Chase 11
Chase 12
Chase 13
6