Ayra TDC Cross 사용자 설명서 - 페이지 8

{카테고리_이름} Ayra TDC Cross에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ayra TDC Cross 11 페이지. Dmx led light effect with 5 lenses

Installation and maintenance

Mounting the bracket

A pre-mounted hanging bracket is provided, with screwknobs at both sides of the fixture. This bracket

can be used to install the unit to a fixed structure, such as a T-bar or truss.

Installing the scanner in a hanging position

When you wish to hang the scanner against a wall, ceiling or beam, make sure to use proper

installation tools and let a skilled technician install the scanner for you.

When you wish to install the scanner to a lighting stand or truss system, use a G-clamp or halfcoupler

for optimal, safe and stable fixation. Check the technical specifications of your light stand or truss

system to gather more information on maximal loads and other safety precautions.

Transport

When using this fixture in mobile setups, provide sufficient protection during transport. Use the original

packaging of this unit, or use a professional flightcase with proper foam inlay. This way the electronics,

optics and housing are protected against severe shocks, exterior damage and failing electronics.

Replacing the internal fuse

First check whether a failing power supply may be the cause of malfunction. When you suspect that

the internal fuse is broken, the fuse can be replaced by removing the fuse cover, located directly below

the power inlet.

WARNING: Before changing the fuse, always disconnect the fixture from your wall outlet or any other

power supply to prevent electric shocks.

Always replace a broken fuse with a fuse that has the same type and rating. After the fuse has been

replaced, always close the fuse-cover. Reconnect the fixture to your power supply and check whether

the problem is solved. When this does not solve your problem, contact your local dealer for help.

Spare parts

This unit has no user serviceable parts inside. When any damage to internal components occur,

contact your local dealer or a specialized technician in order to repair the fixture.

Cleaning:

Clean the housing of the fixture frequently with a damp cloth, to remove dust and/or dirt. WARNING:

Always disconnect the fixture from your wall outlet or other power supply and let the fixture dry before

reconnecting it. This prevents possible electrical shocks.

The lenses can be cleaned with a non-aggressive glass cleaning solution, but is not recommended.

Ayra recommends to clean the mirror and lens with a fine brush, while removing dust and/or dirt with a

vacuum cleaner. Avoid touching the lenses with your bare fingers, to prevent fingerprints on the optics.

Checkup

To prevent dangerous situations, make sure your fixture is in optimal condition before using it. Check

your fixture frequently by using the following checklist:

- All screws must be mounted tightly.

- Check all screws and metal parts for corrosion. No visible corrosion may be present.

- The exterior of your fixture must be in optimal condition. Check your fixture for dents, cracks or

missing parts.

- Your installation spot must be in optimal condition. Check your installation spot for corrosion, cracks,

dents and strength.