Accurion i4 Series 사용 설명서 - 페이지 8

{카테고리_이름} Accurion i4 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurion i4 Series 14 페이지. Active vibration isolation halcyonics workstation

The system may only be transported or moved in the transport-locked condition!

To change the different modes, it is necessary to press and hold the button for some seconds.

Using Active Vibration Isolation

Once you have started up the system, press the "isolation" button on the front panel to enable the active

vibration isolation. Now the system initializes, which is shown by a flashing blue LED. When the system

initializes for the first time or after a long interval, this process can take up to 30 seconds. When the blue

LED remains lit, the active vibration isolation is activated.

The Workstation_i4 has been designed to compensate vibration amplitudes up to 500 µm/s. If vibrations

significantly exceed this level the system changes to the stand-by mode, indicated by a flashing blue

"Isolation" LED. After the overload excitation is stopped, the isolation mode will automatically be turned

on again. After a severe overload the system may take up to 30 seconds to reach full active isolation

performance, but normally only a few seconds are required.

The active vibration isolation will be automatically switched off during overmodulation of the

system. Once this interference has subsided, the system will re-initialize and, after a few seconds,

automatically resume to the active isolation mode. This procedure does not require any action

from the user.

- 8 -